- #Smith and wesson model 10 6 serial numbers serial numbers#
- #Smith and wesson model 10 6 serial numbers series#
#Smith and wesson model 10 6 serial numbers serial numbers#
to leave the S&W factory was an 8 3/4 barrel Gun with serial number one. The 4 best Smith & Wesson Model 10 Serial Numbers images and discussions of November 2021. The older the gun, the possiblity exists for the s/n to appear in more places, for instance on the underside of the barrel (the flat area that is covered from view if the cylinder is closed, swing out the cylinder and look there, I doubt this gun has it there, it appears too late), also check the crane, on the surface that faces the cylinder, you may need to look through the cylinder with a flashlight to see it, or dissassembly may be required. 38 S&W Special +P 6 Inch Barrel Blue 6 Round Single action/double action. The problem with these later guns is that they may have the prefix imbedded within the s/n (example 5D12345), is that in the places - other than the butt - you may see these number show us as 512345, especially the grips, they normally didn't stamp the alpha letter, either as a prefix or imbedded number. ' to educate a mans mind and not educate his morals, you have an educated menance to society' Teddy Roosevelt ' A government big enough to give you everything you need, is strong enough to take everything you have. Also, push the extractor star all the way out, as if you are ejecting spent shells, and look at the underside surface of the star, there should be a number there. You can look at the inside of the right grip panel to see what is stamped there (assuming the grips are original). The s/n will appear on the gun in other places, but the prefix may not be on those other places. 38 Special cartridge loaded to higher pressures than were considered appropriate for earlier revolvers chambered for that.
#Smith and wesson model 10 6 serial numbers series#
38/44 identifies a series of 6 shot, double-action, Smith & Wesson N-frame revolvers chambered for the. Barrels of 2. Over its long production run it has been available with barrel lengths of 2 in, 2.5 in, 3 in, 4 in, 5 in, and 6 in. In production since 1899, the Model 10 is a six-shot.38 Special, double-action revolver with fixed sights. I agree with s&wchad, those numbers appear to be restamped for whatever reason. The serial numbers have no letters, it has a lanyard strap in the grip butt and Trade Mark is on. The Smith & Wesson Model 10, previously known as the Smith & Wesson.38 Hand Ejector Model of 1899, the Smith & Wesson Military & Police or the Smith & Wesson Victory Model, is a K-frame revolver of worldwide popularity.